News articles
|
Commonly Used Terminology in the Cone Crusher IndustryNew cone crusher users may be unfamiliar with some industry terminology found in the instruction manual. To address this, our company's technical staff provides the following explanations:
Feed:Material that needs to be processed by the crusher.
Liner:Refers to both the concave(stationary liner) and the mantle (moving liner).
Crushing Chamber:The internal space formed between the two crushing elements (concave and mantle), where the actual size reduction of the material occurs.
Parallel Zone:The section at the bottom of the concave and mantle where the surfaces are parallel, ensuring consistent product size.
Closed Side Setting : The closest distance between the mantle and the concave during the crushing cycle. It determines the crusher's minimum discharge size.
Open Side Setting : The maximum distance between the mantle and the concave during the crushing cycle.
Discharge Opening:The outlet for the final product. It can be categorized based on requirements, such as minimum discharge gap and open side discharge.
Open Circuit Crushing:A process where material passes through the crusher only once, without a strict requirement for precise product size consistency.
Closed Circuit Crushing:A process where the crusher is coupled with a screening device. Oversized material is recirculated back to the crusher until the desired product size uniformity is achieved. |