News articles

Details

What is the cause of oil leakage in the cone crusher?

The cone crusher is one of the common crushing equipment we use. Through investigating the usage of cone crushers in the past, we found that there may be oil leakage during use. For this situation, it is recommended that users do not panic, find the root cause, and prescribe the right medicine, which is the key. Next, we will explain the main reasons for oil leakage in cone crushers.

It is necessary for us to repair the oil leakage problem or take precautions in this regard only after understanding these reasons. In the maintenance and upkeep of machines, we should observe them to avoid problems and ensure safer production and operation.

1¡¢ Sealing device failure

In production, attention should be paid to checking the wear of the O-ring between the transmission shaft frame and the main frame, the nylon sealing ring between the oil collector and the oil slinger, and the O-ring between the oil slinger and the transmission shaft. After long-term use, some parts may wear and deform, lose the elasticity required for effective sealing, and the sealing device may fail, leading to oil leakage.

2¡¢ Blocked return oil pipeline

One reason why oil leakage cannot be ruled out is that oil cannot be quickly discharged from the equipment, which can occur at low temperatures. Therefore, in production, attention should be paid to checking whether there is any dirt accumulated in the main oil discharge hose or pipeline, and whether there is dirt in the long hole of the transmission shaft frame below the transmission shaft. Otherwise, the accumulation of dirt will hinder the flow of oil, leading to oil leakage in the cone crusher.

3¡¢ Improper work pressure

Lubricating oil enters the lower part of the main shaft through the lubrication friction plate from the oil inlet pipe. If the working pressure of the lubrication system of the cone crusher is not appropriate, the oil will spray out from the shaft gap, causing lubricating oil to leak down along the outer circle of the sealing cylinder.

4¡¢ Unreasonable component clearance

If the gap between the inner wall of the main engine oil pool and the oil blocking ring plate of the counterweight is too small, the lubricating oil thrown between them during the operation of the cone crusher is prone to forming oil seals under tension. Under the push of air pressure, the oil seal will continuously overflow from the dust ring along the inner wall of the main engine seat.


£¨+86£©138-4494-4528

53-3 Honghai Road, Yuhong District, Shenyang City, Liaoning Province, China

Navigation

Mobile official website

Copyright @ 2023 .  Shenyang Fente Mining Machinery Co., Ltd .  All rights reserved.   |   ÁÉICP±¸2023009852ºÅ-1

Technical Support£º ÐÅÍø¿Æ¼¼ | Admin Login
seo seo