News articles
|
Open and closed circuits in the crushing processIn production, we often hear about two sections with one closed circuit, three sections with one closed circuit, and three sections with one open circuit. What does that mean? Two or three paragraphs, as you may all understand, refer to the number of segments in the crushing process. The entire sand and gravel production line includes stages such as coarse crushing, medium crushing, fine crushing, and ultra fine crushing. Each stage has corresponding processing equipment, and the process of processing stones into the required finished products through the operation of the equipment is called the crushing process. Usually, there are two stages of crushing, three stages of crushing, and four stages of crushing. The second and third stages are more commonly used, while the fourth stage is rarely used. It mainly appears in large sand and gravel plants and is used to crush hard and large-sized stones. What do closed circuit and open circuit mean? What are the characteristics? During the operation of the crusher, its crushing and screening are combined operations. Before crushing, the material that needs to be crushed usually contains some smaller particles. Screening them before crushing can improve the crushing efficiency. In the crushed materials, due to the different principles of crushers, there are often some materials with relatively large particle sizes. For large particle materials that do not meet the standards, screening is also necessary for multiple crushing. To achieve better performance, it is very important to closely cooperate with the screening system for crushers. Usually, crushers and various screening systems are mainly composed of two working modes: open circuit and closed circuit. Open circuit crushing process and characteristics When the material passes through the crusher at once but the screened material does not enter the crusher, it is an open circuit crushing process. Characteristic analysis: For open circuit production, the particle size of the product is controlled by the discharge port of the crusher. In addition, the discharge port is only the width of a long "slot" and can only control the one-dimensional size of the material. If long and flat rocks are small enough in size, they can pass through the discharge port. In other words, the product granularity obtained from the open circuit process is not particularly effectively controlled. Closed circuit crushing process and characteristics Unlike the open circuit crushing process, the closed circuit process has an inspection and screening process. It can be understood that there are basically two types of crushing systems: pre screening and inspection screening. Those without screening or with only pre screening are open circuit processes, while those with inspection screening are closed circuit processes. Characteristic analysis: There are various combinations of equipment in the closed-loop crushing process. Typically, the screening machine is installed behind the crusher to allow the screened material to return to the crusher, and the product particle size is controlled by the sieve holes on the screen surface (i.e., two-dimensional size control). The sieve hole is not adjustable like the discharge port. Flat and sheet-like materials also enter the recycled material flow, allowing closed-loop operations to improve the shape of the product and obtain more standardized products. The crusher must accept recycled materials, indicating a corresponding reduction in the amount of new feed that the circuit can accept. If the mesh size is reduced as much as possible, the resulting product will be finer, but the amount of recycled material will increase. The net processing capacity of the circuit generally decreases. The crushing rate obtained while reducing processing capacity is relatively high. However, as the amount of material recycling increases, the product particle size will not significantly decrease. When the particle size of the separated material is much smaller than the narrow end of the discharge port of the crusher, the crushing circuit will appear unstable. In summary: (1) Simply put, the difference between open circuit and closed circuit processes lies in the screening stage. Open circuit processes have no screening stage or only pre screening stage, while closed circuit processes have a screening inspection stage, which can effectively screen out large blocks of material and improve the crushing rate of the entire process. (2) The advantages of the open circuit process are simplicity, fewer equipment, and fewer sand lifting points. The disadvantage is that when the particle size of the crushed product is required to be finer, the crushing efficiency is lower, and sometimes the product may contain a small number of finished products larger than qualified products. (3) The closed circuit process can screen out large blocks to ensure that the product particle size is qualified, and the crushing efficiency is higher than that of the open circuit, but it requires more equipment and the process is more complex. |